Publicidad
Idiomas disponibles
Idiomas disponibles
Insert the food probe
•
Before selecting which cycle to use, the probe must be inserted into the food. This allows the internal
temperature of the food to be measured.
•
It is important that the probe is correctly connected to the unit.
Note: To prevent bacterial contamination or contamination of any other
biological nature, the needle probe must be disinfected after use.
Control Panel
Compressor
Defrost
Evaporation fan
Temperature
controlled cycle
SET,
keypad lock
Switching the appliance on
•
Power up the device and switch on.
•
If the device is switched on and no cycle is active, the display will show the cabinet temperature.
•
If the display shows an alarm code, see the section "Alarms".
•
If no cycle is active, after 10 seconds have elapsed without the keys being pressed, the display will
automatically switch off, except for the low consumption LEDs.
•
When 60 seconds have elapsed without the keys being pressed, the display will show the "Loc" label
and the keypad will lock automatically.
Switching the display back on
Touch a key
Unlocking the keypad
Touch a key for 1 second. The display will show the label "UnL".
Silencing the buzzer
Touch a key
CK640_ML_A5_v5_20221025.indb 17
CK640_ML_A5_v5_20221025.indb 17
Conservation
Alarm
DOWN,
Start/Stop
Additional functions
EN
Temperature unit
Time unit (minute)
Time controlled
cycle
Low consumption
UP,
Defrost
17
2022/10/25 17:35
2022/10/25 17:35
Publicidad
