Polar CK640 Manual De Instrucciones página 3

Quick Start Guide
Control panel
Compressor
Defrost
Evaporation fan
Temperature
controlled cycle
SET,
keypad lock
Set-Temperature positive blast chilling and storage cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still in
cycle mode, press the Start/Stop button
• Once in "Standby" mode, press
• Press within 15 s to view the product temperature at the end of blast chilling.
• To adjust the temperature, press
• Press or take no action for 15 s, to save the new parameter.
• Press to start the cycle. The cycle will take 2 minutes to start. The temperature LED
flashing once
Please be aware, if previous cycle was a negative, a positive cycle will not run until device
is back up to temperature.
The settings are temporary. When a new cycle is activated (and after a power failure), the
device will restore the r3/r4, r5/r6, r7/r8 and r9/rA values.
Set-Temperature negative chilling and storage cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still in
cycle mode, press the Start/Stop button
• Once in "Standby" mode, press
• Press within 15 s to view the product temperature at the end of blast chilling.
• To adjust the temperature, press
• Press or take no action for 15 s, to save the new parameter.
• Press to start the cycle. The cycle will take 2 minutes to start. The temperature LED
flashing once
Please be aware, The settings are temporary. When a new cycle is activated (and after a
power failure), the device will restore the r3/r4, r5/r6, r7/r8 and r9/rA values.
CK640_ML_A5_v5_20221025.indb 3 CK640_ML_A5_v5_20221025.indb 3
Conservation
Start/Stop
for 2 seconds to clear.
to select "PoS" and ensure the temperature LED
, then press
is pressed. The temperature LED
for 2 seconds to clear.
to select "nEG" and ensure the temperature LED
, then press
is pressed. The temperature LED
Alarm
DOWN,
Additional functions
to reduce or
will then remain ON.
to reduce or
will then remain ON.
3
EN
Temperature unit
Time unit (minute)
Time controlled
cycle
Low consumption
UP,
Defrost
is flashing.
to increase the value.
will start
is flashing.
to increase the value.
will start
2022/10/25 17:35 2022/10/25 17:35