Polar CK640 Manual De Instrucciones página 2

Quick Start Guide
Control panel
Compressor
Defrost
Evaporation fan
Temperature
controlled cycle
SET,
keypad lock
Timed positive blast chilling and storage cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still in
cycle mode, press the Start/Stop button
• Once in "Standby" mode, press
• Press within 15 s to show the pre-set time.
• To adjust the time, press
• Press or take no action for 15 s, to save the new parameter.
• Press to start the cycle. The cycle will take 2 minutes to start. The timer LED
once is pressed. The timer LED
Please be aware, if previous cycle was a negative, a positive cycle will not run until device
is back up to temperature.
The settings are temporary. When a new cycle is activated (and after a power failure), the
device will restore the r3/r4, r5/r6, r7/r8 and r9/rA values.
Timed negative chilling and storage cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still in
cycle mode, press the Start/Stop button
• Once in "Standby" mode, press
• Press within 15 s to show the pre-set time.
• To adjust the time, press
• Press or take no action for 15 s, to save the new parameter.
• Press to start the cycle. The cycle will take 2 minutes to start. The timer LED
once is pressed. The timer LED
Please be aware, The settings are temporary. When a new cycle is activated (and after a
power failure), the device will restore the r3/r4, r5/r6, r7/r8 and r9/rA values.
CK640_ML_A5_v5_20221025.indb 2 CK640_ML_A5_v5_20221025.indb 2
Conservation Alarm
DOWN,
Start/Stop
Additional functions
for 2 seconds to clear.
to select "PoS" and ensure the timer LED
, then press to reduce or
will then remain ON.
for 2 seconds to clear.
to select "nEG" and ensure the timer LED
, then press to reduce or
will then remain ON.
2
EN
Temperature unit
Time unit (minute)
Time controlled
cycle
Low consumption
UP,
Defrost
is flashing.
to increase the value.
will start flashing
is flashing.
to increase the value.
will start flashing
2022/10/25 17:35 2022/10/25 17:35