Polar CK640 Manual De Instrucciones página 22

EN
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
Condensation will form in refrigeration with frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to drain properly or is wiped dry.
Cleaning the condenser
• Periodically cleaning the condenser can extend the life of the appliance.
• POLAR recommend that a POLAR agent or qualified technician clean the condenser.
Cleaning the water pan
• The water pan is located underneath the evaporator at the back of the unit.
• To remove it for cleaning, simply slide out when necessary.
Alarms
Code Meaning
Pr1 Cabinet probe alarm
Pr2 Needle probe alarm
AL Low temperature alarm
AH High temperature alarm
id Door open alarm
iA Multi-purpose input alarm
22
CK640_ML_A5_v5_20221025.indb 22 CK640_ML_A5_v5_20221025.indb 22
Reset To correct
Automatic • Check P0
• Check integrity of the probe
Automatic • Check electrical connection
Automatic Check A1 and A2
Automatic Check A4 and A5
Automatic Check i0 and i1
Automatic Check i0 and i1
2022/10/25 17:35 2022/10/25 17:35