Descargar Imprimir esta página

FujiFilm FUJINON STABISCOPE S1240 Manual De Instrucciones página 21

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
Maintenance
Care and Cleaning
The STABISCOPE is built to withstand heavy duty use, but it should still be treated with care. When not
in use, it should stored in a cool, dry environment in its own case. If it will stored for prolonged periods,
the batteries should be removed. Although the STABISCOPE is waterproof, it should be protected from
unnecessary exposure to water and humidity. In hot weather, the STABISCOPE should not be kept in-
side a closed vehicle where heat could reach damaging levels.
Protect your eyes. Never use the STABISCOPE to look directly at the sun. It is extremely dangerous and
can cause eye damage.
Keep your STABISCOPE clean.
Lenses should be kept free of dust, salt and the oils that remain from fi ngerprint smudges. These oils
can actually damage the Electron Beam Coating (EBC) applied to the lens surfaces.
To clean the lenses...
1.
Use a soft, lint-free cloth and a good lens cleaner or alcohol.
2. Clean by rubbing the lens gently, in a circular motion, starting in the center and working your way
to outer edges. If there is dust on the surface, blow it off prior to applying the cleaning cloth.
To clean the body and case...
Clean with a soft cloth, moistened if necessary. Be sure the STABISCOPE is completely dry before plac-
ing into its case. The case can be cleaned the same way.
Symptoms and Solutions
The most frequent problems are usually the easiest to solve.
Symptom
Targeted image is un-
stable
Gyro motor does not
rotate
LED fails to light
Blurred image
If you experience any problems with your STABISCOPE not covered above, never attempt to repair it
yourself, instead, contact the dealer where you purchased the binoculars
Cause
Weak batteries
Batteries are in wrong
position
Weak batteries
Out of focus
Stain on lens surface
Haze, mist or strong glare
ENGLISH
Solution
Replace batteries or switch to external
power source
Check battery polarity and replace in
correct position
Replace batteries or switch to external
power source
Adjust eyepieces
Clean
Use fi lters
EN-8

Publicidad

loading

Este manual también es adecuado para:

Fujinon stabiscope s1640