Trust START-LINE AWST-8800 Manual De Instrucciones página 5

9. Manual operation of a Trust Smart
Home electric screens receiver
A
Send an ON-signal to raise the screen.
B Send an ON-signal again to stop.
C
Send an OFF-signal to lower the screen.
D Send an OFF-signal again to stop.
Read the receivers manual to reverse the
direction of the screen, if needed.
10. Replace transmitter battery
A
Use a flathead screwdriver to remove the
button first.
B Then place the flat screwdriver in the recess of
the frame and lift the screwdriver to unclip the
frame from the back plate.
C
Remove the battery by inserting the flat
screwdriver into the slot and sliding the
battery out.
D When replacing the push button, make sure
that the recess of the push button is on the
same side as the recess of the frame.
Insert a new CR2032 battery. Make sure the +
side is facing up. The wireless wall switch is now
ready for use again.
AWST-8800 WIRELESS WALL SWITCH
EN
5