Publicidad
Idiomas disponibles
Idiomas disponibles
FCC
FEDERAL COMMUNICATIONS
COMMISSION
JAPAN ELECTRICAL SAFETY
TÜV RHEINLAND
DOUBLE INSULATION
BACK FEED PROTECTION
PROPERLY RECYCLE BATTERY
DO NOT THROW IN GARBAGE
BC
CALIFORNIA - TITLE 20
COMPLIANT
Battery Pack
Specifications
Type
CTB8172BK ....................................... Lithium-Ion
Voltage
CTB8172BK .................. 14.4 VDC (3.6 V x 4 cells)
Weight
CTB8172BK .............................. 0.51 lbs (0.23 kg)
Charge Time
CTB8172BK ...............................................55 min
Life
CTB8172BK ....................................... 1000 cycles
Note: 1 cycle=1 charge and 1 discharge
Capacity
CTB8172BK ..............................................2.0 A•H
Discharge Temperature Range
CTB8172BK .............. -4°F(-20°C) to 140°F(60°C)
Battery Charger
Specifications
Input
CTC772A/CTCA772A/CTCEU772A/CTCJ772A .......
........................................
Output
All Models .....................................................3.0 A
ZCTPP761ACE Rev. A
100-240 VAC, 50/60 Hz
Weight
All Models ................................. 1.15 lbs (0.52 kg)
Charging Temperature Range
CTB8172BK ................. 32°F(0°C) to 113°F(45°C)
DO NOT BLOCK VENT OPENINGS!
Tool Operation
Fuel Gauge
The tool is equipped with a fuel gauge to indicate the
battery's state of charge. It is located on the left side of
the tool at the top of the handle. A round tri-color LED
changes color depending on state of charge. The gauge
is activated for three seconds at each trigger pull. The
following describes its function:
• LED IS GREEN - Battery is between 40% and 100%
charged
• LED IS YELLOW - Battery is between 25% and 40%
charged
• LED IS RED - Battery is between 0% and 25% charged
• LED IS FLASHING RED - Battery needs charging
immediately
Switch
The switch can be placed in the forward or lock position.
Switch is shown in forward or clockwise rotation.
Depress forward/lock bar "A" to place switch in the
center lock position.
Trigger
Depress the trigger to rotate the disc pad. The trigger
must be in the forward position to operate. The trigger
can be locked in the OFF position. Locking the trigger in
the OFF position helps to reduce the possibility of
accidental starting the tool when not in use. Place the
lever in the center position to lock the trigger.
Lock the trigger when not in use.
9
Figure
2:
(06/17)
Publicidad
