Zipro Boost Gold Manual De Uso página 12

EN
2. Install the right and left pedal
Screw the left and right pedal (9L/R) to the crank (8). Screw the right pedal bolt
(9R) on clockwise. Screw the left pedal bolt (9L) counterclockwise.
NOTE! The right pedal is marked 'R' and the left pedal is marked 'L'.
3. Install the saddle
Fix the saddle (33) and a towel holder (47) to the saddle guide (34) using nuts
(41) and flat washers (40).
Fix the guide (34) with the saddle (34) to the saddle post (36).
Set the saddle (33) to the right position and lock it with the horizontal
adjustment knob (39) and washer (38).
Slide the post (36) with the saddle (33) into the rear part of the main frame.
Position the saddle at the desired height and lock it with the vertical
adjustment knob (29).
NOTE! Do not exceed the maximum and minimum height when adjusting the
saddle height.
NOTE! Before using the device, make sure the saddle is stable in the guide.
4. Install the handlebar column
Install the cover (22) onto the handlebar post (17).
Connect the computer cable (11) to the connecting cable (13) and the
resistance adjustment cable (12) to the resistance adjustment connecting
cable (25) as shown below.
Slide the nut of the upper resistance adjustment cable (25) into the slot in
the bracket of the lower resistance adjustment cable (12), pull and tighten the
upper cable (25) and move the lower cable bracket (12) vertically.
Cable nut should be on the bracket as shown in the picture.
Insert the handlebar column (17) into the main frame (1) and fix it with Allen
bolts (14) and curved washers (6).
12