Descargar Imprimir esta página

Halo PRIME 550 Guia Del Usuario página 36

Ocultar thumbs Ver también para PRIME 550:

Publicidad

Idiomas disponibles

Idiomas disponibles

PELLET GRILL WILL NOT ACHIEVE OR MAINTAIN TEMPERATURE
P O S S I BL E C AU SE:
Insufficient Air Flow
Through Burn Pot
Lack Of Fuel, Poor Fuel
Quality, Obstruction In
Feed System
Temperature sensor
(RTD)
PELLET GRILL PRODUCES EXCESS OR DISCOLORED SMOKE
P O S S I BL E C AU SE:
Grease build-up
Quality of wood pellets
Blocked burn pot
Insufficient air intake
for fan
FREQUENT FLARE-UPS
P O S S I BL E C AU SE:
Cooking temperature
Grease build-up on
cooking components
36
36
SO LU TI O N:
Check burn pot for ash build-up or obstructions. Follow Care and Maintenance
instructions for ash build-up. Check the fan to make sure it is working properly, and
air intake is not blocked. Follow Care and Maintenance instructions if dirty. Check
auger motor to confirm operation, and make sure there is no blockage in the auger
tube. Once all the above steps have been done, start the pellet grill, set temperature
to 300°F (148°F) and ignite the pellet grill. Check the fire is bright and vibrant.
Check hopper to check that fuel level is sufficient and refill if low. Should be
poor quality of wood pellets, or the length of the pellets too long, this may cause
an obstruction in the hopper and auger. Remove pellets and follow Care and
Maintenance instructions.
Check status of temperature probe. Follow Care and Maintenance instructions if
cover with creosote. Contact Consumer Service for a replacement part if damaged.
SO L UTI O N:
Follow Care and Maintenance instructions.
Remove moist wood pellets from hopper. Follow Care and Maintenance instructions
to clean out. Replace with dry wood pellets.
Remove moist wood pellets from burn pot and hopper and clear the auger tube by
select Clean Out mode.
Check the fan and make sure it is working properly and air intake is not blocked.
Follow Care and Maintenance instructions if dirty.
SO L UTI O N:
Attempt cooking greasy food at a lower temperature. Grease does have a lower flash
point. Keep the temperature under 350°F (176°C).
Follow Care and Maintenance instructions.
Halo Consumer Service
Toll-free: (833) 572-1688

Publicidad

loading