Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Installer Setup
Once the SDW01 controller has established commu-
nication with the indoor unit, the initial settings for the
indoor unit and SDW01 controller can be configured
as described below.
1) Press the dial to open the general menu at the top
of the screen, then scroll to the right and select
"settings" by pressing the dial again.
2) Scroll down and select "Installer".
3) To configure the indoor unit settings, select "Function
Codes". The controller will populate a list based on
the available Function Codes from the indoor unit.
4) Select the Function Code (1-28) you wish to configure,
then select the desired value (1-3) to make the change.
5) To configure the controller settings, select "ISU".
(Installer Setup Options)
6) Select the ISU you wish to configure, then select
the desired setting to make the change.
Installer Menu Options
Function Codes: This is used to access the indoor unit's
built-in initial settings. Changes made to these settings
will remain active indefinitely, even if the SDW01 is
disconnected and replaced with another controller.
ISU: This is used to access the controller's initial set-
tings. Changes made to these settings will only remain
active while the controller is connected. If the SDW01
is disconnected and replaced with another controller,
all settings will revert to their default state.
Error Codes: This is used to access the Error Code
history reported by the indoor unit.
Factory Reset: This will reset the controller to its
factory state.
Test Mode: This will run the unit in cooling or heating
to test system performance.
SDW01 Installation Manual
Note: To see a list of all configurable indoor
unit settings, go to the Function Code tables
on pages 8-9.
Note: To see a list of all configurable controller
settings, go to "Installer Setup Options (ISU) –
Advanced Menu" on pages 10-11.
4
Publicidad
