YATEK ECO Manual Del Usuario página 24

Inversion Table Assembly Instructions Yatek ECO
STEP 6:
In this step we are going
to join the assembled
piece in step 5 with the
right and left handles.
First make sure to grab
the following parts for this
step:
• Assembled piece in
step 5
• 2 x Nº 10 – Left and
right handlebars
• 4 x Nº 14 –
Hexagonal bolt
• 8 x Nº 15 – Flat
washer
• 4 x Nº 18 – Anti-
release nut
➢ First step: Use the hexagonal bolts (14), the flat washers (15) and nuts (18) to assemble
both handlebars (10) in the back support (2) according to the direction in the illustration.
➢ Second step: During the use, after holding the feet, insert the safety pin (21) in the hole of
the rotating toothed disc (to ensure the feet holder).
HTTPS://WWW.ELECTROPOLIS.ES
English
22