Twister be cool Manual Del Usuario página 54

EN
1.1 Checking the shoulder strap height
NO-Too low
Always check that the shoulder straps are at the same
correct height for your child. The child's shoulders
should always be thread through the slots in the cover
and seat shell that are closest to the top of your child's
shoulders.
1.2 Usage of buckle
Firstly, adjust the shoulder straps height, please
proceed as follows:
Step 1. Put the two metal sections of the buckle
connector together.
Step 2. Slot the two buckle connectors into the slot
in the buckle until they "click" in place.
Step 3. Check the harness is correctly locked by
pulling the shoulder straps upwards.
To release the harness, you can press the red button
of the buckle downwards the two metal sections will
be pop up.
54
NO -Too high Yes- Correct
1.3 Adjust and use the harness
Loosen the harness
The harness is slackened by pressing the adjuster
button of the central adjuster on the front of the seat.
Press down the adjuster button as you grip the two
shoulder straps with your another hand.
Pull the shoulder straps towards you to loosen the
harness.
Tighten the harness
Pull the shoulder straps upwards to remove the slack
from the lap sections of the harness then pull the
adjuster strap until the harness is fully tightened.
The harness should be adjusted as tightly as possible
without causing discomfort to your child.
A loose harness can be dangerous. Check the harness
adjuster and tighten each time the child is placed in
the seat.