Twister be cool Manual Del Usuario página 62

EN
WARNING: DO NOT use rearward facing child seat in
seating positions where an active frontal airbag
installed . Death or serious injury can occur.
To disassemble your baby and the child seat, repeat
the above prescribed procedures in reverse order.
2.6 Securing your child in the enhanced child seat
Forward Facing: Child height 76cm-105cm/ Child
weight≤19 kg;
Recline position: Position 1, position 2, position 3,
position 4, position 5.
1. Press the strap adjustment button, while pulling out
the shoulder harnesses to the proper length.
2. Press the red button to disengage the buckle.
3. Fix the two metal sections of the buckle connector
on the both sides of the enhanced child seat.
4. Place the child into the enhanced child seat and
pass both arms through the harnesses. Position the
62
harness straps at or below the child's shoulders.
After the child is seated, re-check whether the shoul-
der harnesses are at the proper height.
Check and adjust the height of the shoulder straps
and headrest to the correct position according to your
child's height.
5. Engage the buckle and put the two metal sections
of the buckle connector together. Slot the two buckle
connectors into the slot in the buckle until they "click"
in place.
Check that the harness has not become twisted and
also check that the cover is not impeding the move-
ment or fit of the harness in any way.
6. Pull forward the adjustment strap and adjust it to
the proper length to make sure your child is snugly
secured.
7. Make sure the space between the child and the
shoulder harness is about the thickness of one hand.
Adjust the child seat to desire of recline position and
make your child comfortable.