Twister be cool Manual Del Usuario página 58

EN
1.8 Using the baby insert
The baby insert must be used for the child height of
40-75cm.
Place the baby insert in the enhanced child seat and
press the snap fastener of the head extra cushion of
baby insert with the headrest of the enhanced child
seat, then lay both shoulder straps over the baby
insert.
Guide the harness buckle and the crotch pad through
the openings in the bottom part of the baby insert.
Always make sure that your child is properly secured.
To take off the baby insert, repeat the above pres-
cribed procedures in reverse order.
2. USING THE SIDE PROTECTOR
During the travel, you can choose to use the side
protector.
58
If you want to use the side protector, press the side
protector button, you will hear a "click" and the side
protector is open.
During the travel, you only can open the side protector
which is near to the door of the car.
If you do want to use the side protector, Press the side
protector button, at the same time, press the side
protector, you will hear a "click" and the side protector
is close and locked.
2.1 Removal baby inserts, shoulder pads, crotch pad
and conceal shoulder strap, crotch strap and buckle.
Step 1: Take off the baby inserts, please refer to
Section 1.8.
Step 2: Press the adjuster button and loosen shoulder
harness, open the shoulder strap pads and slide
shoulder pads straps off its own connectors from
the front of the enhanced child seat and move
shoulder pads.