Publicidad
Idiomas disponibles
Idiomas disponibles
Unfolding / folding plant
Q
protector
CAUTION! RISK OF INJURY!
Adjust the plant protector
u
when the product is switched off and the
cutting device is at a complete stop!
Use the plant protector
obstacles that could be hit by the cutting device.
1.
Fold down the plant protector
trimming / edging operation (see Fig. L).
2.
Fold up the plant protector
and storage.
Switching on and off
Q
Switching on:
1.
Hold the product with one hand on the rear
handle
and with the other on the front
3
handle
.
7
2.
Press the lock-off button
hold it in position.
3.
Press the on / off switch
product on (see Fig. M). Release the lock-off
button
afterwards.
5
Switching off:
WARNING!
The trimming spool
u
for some time even after the motor has
been switched off! Wait until it comes to a
complete stop before you put the product
down!
1.
Release the on / off switch
product off.
Line feeding
Q
CAUTION! RISK OF INJURY!
The trimming line will be thrown
out! Danger of injury especially for
bystanders!
During use, the tip of the trimming line will get
shorter due to wear. Regularly check the condition
of the trimming line
23
34 GB / IE
position only
15
to keep distance to
15
for
15
for transport
15
to either side and
5
4
to switch the
will continue to rotate
22
to switch the
4
and adjust if necessary. The
trimming spool
is equipped with a bumper
22
helping to cut the trimming line
1.
Tap the bumper
21
trimming spool
22
(see Fig. N).
2.
Excess line will be cut by the knife
should always remain inside the radius of the
guard
.
13
NOTE
The line feeding system works only when the
u
product is switched on.
The trimming line will wear faster and
u
require more feeding if cutting is done along
sidewalks, other abrasive surfaces or heavier
weeds are being cut.
Trimming
Q
1.
Fold down the plant protector
2.
Adjust the angle of trimmer head
trimming operation.
3.
Hold the product firmly with a gap between
the product and your right side.
4.
Stand upright, do not lean forward and pay
attention to posture. Keep both feet apart to
help retain your balance.
5.
Hold the trimmer head
ground at an angle of approximately 30°.
6.
Move the product with a slow regular arc
from left to right before moving it back to the
starting position before trimming the next area
(see Fig. O).
7.
Ensure the cutting attachment remains clean
and free from off-cuts that may cause it to
jam. Check regularly. Release the on / off
switch
and remove the battery pack
4
before checking.
8.
Trim longer grass in stages; do not cut long
grass in one cut. For the best results, cut
longer grass in steps (see Fig. P).
Edging
Q
1.
Fold down the plant protector
2.
Adjust the angle of trimmer head
for edging operation.
3.
Push the product forwards using the
wheel
(see Fig. Q).
14
21
while operating.
23
on solid ground and the
will release trimming line
and
16
.
15
to 0° for
17
just above the
17
27
.
15
to 90°
17
Publicidad
