Publicidad
Idiomas disponibles
Idiomas disponibles
Tips
Q
For best results, do not cut wet grass because
o
it tends to stick to the trimmer head
guard
, prevents proper discharge of
13
grass trimmings, and could cause you to slip
and fall.
Pay special attention when performing the
o
work close to trees and bushes. The trimmer
head
could damage sensitive bark, and
17
damage fence posts.
Fold down the plant protector
o
bringing the cutting device into contact with
hard objects such as walls and curb stones
(see Fig. R).
NOTE
The trimming line will wear faster and
u
require more feeding if cutting is done along
sidewalks or other abrasive surfaces or
heavier weeds are being cut.
While trimming, the cutting device is possible
u
to be blocked by grass or unevenly ground.
So the product will turn off automatically due
to over current. Therefore release the on / off
switch
for over 3 seconds and then press
4
down again to go on with trimming.
After use
Q
1.
Switch the product off, remove the battery
pack
and let it cool down.
27
2.
Check, clean and store the product (see
"Cleaning and care").
Cleaning and care
Q
WARNING!
Always switch the product off, remove
the battery pack and let the product
cool down before performing inspection,
maintenance and cleaning work!
Cleaning
Q
The product must always be kept clean, dry
o
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product.
o
and
17
o
o
o
o
NOTE
to avoid
15
u
Maintenance
Q
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see "Technical data").
Replacing the trimming spool
Q
NOTE
u
Replace the trimming spool
or worn.
1.
2.
3.
4.
5.
6.
7.
8.
Inspect the product before each use for worn
and damaged parts. Do not operate it if you
find broken and worn parts.
Never allow fluids to get into the product.
Clean the product with a dry cloth. Use a
brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and brush.
Remove stubborn dirt with high pressure air
(max. 3 bar).
Do not use chemical, alkaline, abrasive or
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.
There is a spring
inside the housing.
24
Ensure it does not get lost.
Switch the product off and remove the battery
pack
.
27
Turn the trimmer head
Press the latches
on both sides to
20
disengage them from the housing
Remove the cover
together with the
19
trimming spool
(see Fig. S).
22
Clean the housing
before inserting a new
26
trimming spool
of the same type.
22
Lead the trimming line endings
eyelets
on the housing.
25
Refit the cover
onto the housing
19
Ensure the latches
are properly engaged
20
in position.
Ensure the cover is correctly fitted before
releasing it. Otherwise, due to spring action it
may be ejected and cause injuries.
when it is empty
22
upside down.
17
.
26
through the
23
.
26
GB / IE
35
Publicidad
