Hilti TE 3-M Manual Del Usuario página 12

Drilling diameter
range in
concrete/masonry
(hammer drill bit)
Drilling diameter
range in
concrete/masonry
(hammer drill bit)
Drilling diameter
range in wood (solid)
Drilling diameter
range in wood (solid)
Drilling diameter
range in metal
(solid-head drill bit)
Drilling diameter
range in metal
(solid-head drill bit)
Storage temperature
Ambient temperature
for operation
5 Operation
TE 3-M
Changing the quick-release chuck
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove in the product.
Fitting/removing the drill bit or other accessory: SDS quick-release chuck
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
TE 3-M
Fitting/removing the drill bit, chisel or other accessory: Three-jaw chuck
Drilling without hammering
Screwdriving
Drilling with hammering action (hammer drilling)
Setting the chiseling function
Chisel positioning
CAUTION
Risk of injury Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the
function selector switch until it engages in the "Chiseling"
6 English
TE 3-M
5/32 in ... 1 1/8 in
4 mm ... 28 mm
1/16 in ... 3/4 in
1.5 mm ... 20 mm
1/16 in ... 1/2 in
1.5 mm ... 13 mm
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
TE 3-C
5/32 in ... 1 1/8 in
4 mm ... 28 mm
1/16 in ... 3/4 in
1.5 mm ... 20 mm
1/16 in ... 1/2 in
1.5 mm ... 13 mm
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
position.
2058841
*2058841*
3
4
5
6
7
7
7
7
7