Descargar Imprimir esta página

Hilti TE 30-A36 Manual De Instrucciones página 17

Ocultar thumbs Ver también para TE 30-A36:

Publicidad

Idiomas disponibles

Idiomas disponibles

Set the function selector switch to the
changing the chuck.
1. Remove the battery from the tool.
2. Grip the chuck as shown in the illustration and pull the three chuck
release rings upwards.
3. Lift the chuck upwards away from the tool.
5.1.7 Fitting the chuck
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the
operator.
▶ Remove the depth gauge from the product.
When changing the chuck, set the function selector switch to this
position:
.
1. Remove the battery from the tool.
2. Grip the chuck as shown in the illustration and pull the three chuck
release rings upwards.
3. Fit the chuck onto the chuck mount.
4. Rotate the chuck until it engages in position.
5.1.8 Inserting the tool
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
5.1.9 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Pull the tool lock back as far as it will go and remove the accessory tool.
*2173713*
6
7
7
2173713
"Chiseling" position for
English
11

Publicidad

loading