Sony XM-8ES Manual De Instrucciones página 9

Changing the heat sink cover direction
The direction of the heat sink cover can be changed
according to your preference.
1
Slide the cover forward, then lift to remove
it.
2
Rotate the cover to your desired direction.
3
Align the cover to the catches on the
amplifier, then slide the cover back until it
clicks into place.
Connection
• Before making any connections, disconnect the
ground (earth) terminal of the car battery to avoid
short circuits. Connect this amplifier to the +12 V
power supply lead only after all other leads have
been connected.
• This amplifier is designed for negative ground
(earth) 12 V DC operation only.
• Do not operate the amplifier on a weak battery as
the amplifier requires a good power supply for
optimum performance.
• If your car is equipped with a computer system for
purposes such as navigation, disconnecting the
ground (earth) terminal of the car battery may
damage the computer memory. Leave the ground
(earth) lead connected and connect this amplifier
to the +12 V power supply lead only after all other
leads have been connected to prevent short
circuits.
• When connecting and installing the input and
output cables, keep them away from the +12 V
power supply lead. Running them close together
may generate interference noise.
Notes on making connections
• To connect to the terminals on the connector
panel and to adjust various settings, remove the
top cover to access the control panel (top panel).
• When you tighten the screw, be careful not to
apply too much torque as doing so may damage
the terminals or cables.


9
EN