Cuda surgical LLS-LHD-30 Manual Del Usuario página 10

NOTE: When attaching or detaching the USB-C cable, grab the cable by the connector
housing instead of the wire to avoid damage to the cable.
4.4. HD Video Receiver Setup
Connect the provided power adaptor to the HD Video Receiver. Connect the provided
HDMI cable from the back of the HD Video Receiver to an appropriate monitor.
1. Network Indicator Light
2. Video Indicator Light
3. Mini-USB (not used)
5. SYSTEM STARTUP AND OPERATION
To turn on the Recording Unit, Press and hold the ON/OFF button for three to five seconds
until the device beeps.
5.1. Wireless Transmission Verification
Check the Network and Video Indicator lights. An illuminated Network Indicator light
signifies that communication has been established between the Recording Unit and HD
Video Receiver. An illuminated Video Indicator light shows that the HD Video Receiver is
receiving and transmitting a video signal. If either indicator light is off, then restart the
Recording Unit and/or reposition the HD Video Receiver.
After the Recording Unit and HD Receiver have initialized, the camera image will be
displayed on the screen.
®
LIT-247 -
CUDA SURGICAL
Rev. C
1
2
Figure 6. HD Video Receiver
4. HDMI Output
5. Input Power Jack
Page 10 of 98
3
4
5
(English)