Descargar Imprimir esta página

Craftmade Burke BRK60 Guia De Instalacion página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you
do not wish to use the wall control, please proceed
to Section 7 below to continue with fan
installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function
unless battery is installed.
WARNING: Battery is to be inserted with the
correct polarity.
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws
from original wall switch. Attach wall plate
(included) to wall control using 2 screws
provided with the wall control.
7. Fan Assembly.
Remove motor assembly from j-hook on
mounting plate. Then, raise motor assembly to
mounting plate again, aligning slotted holes at
top of motor assembly with loosened screws on
mounting plate. Twist motor assembly to lock.
Re-insert the 2 screws that were previously
removed (Section 4, page 5) and then tighten
all 4 screws to secure motor assembly.
WARNING : It is extremely important to tighten
motor mounting screws completely so that fan
is mounted securely.
outlet box
green/
green/
green/
bare
bare
bare
ground
ground
ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
slotted hole
page 7
wall
control
-
1 1
-
2 2
green
face-
plate
plate
mounting
plate
j-hook
motor
assembly

Publicidad

loading