Publicidad
Idiomas disponibles
Idiomas disponibles
DISPLAY SET-UP
The heat counter is equipped with a liquid cry-
stal display, 8 figures and special letters.
There are three information "levels" as follow:
DISPLAY
Level
1) Energy used in MWh – standard
display
2) Test of the display. Make sure all the
display sections are displayed
simoultaneously.
3) Value reading at a fixed date.*
The value is displayed by turn with the
actual date
Level
1) Maximum power in kW
2) Maximum capacity in m
3
/h
3) Input temperature in °C
4) Output temperatures in °C
Level
1) La test reading, by turns with
the relevant date
* Up to the end of the month, the data about the use and the date are displayed to zero.
54
a) Main level
b) Technical level
c) Statistical level
The information is recalled by pressing the
button. A short press of the button will step
3) Value reading at a fixed date.*
The value alternates with the actual date
4) Total voilume (in m3) from the
installation
5) Instantaneous power in KW
5) Temperatures difference
6) Days of functioning from calibra-
tion
7) Impulses values per litre
8) M-bus address
2-16) Reading of the use over the la
test 15 months, alternate with the
through the information at each level.
Holding the button presses will move throu-
gh the levels.
After 1 minute of non-use, the display
returns back to the standard screened.
6) Instantaneous flow rate in m3/h
7) Date
8) Error code
9) Serial number
10) Firmware/software version
Publicidad
