en Installing the base station
¡ You can delay the natural wear by using
the following measures:
– Only charge the battery in the temper-
ature range between 0 °C and 45 °C.
– Only store the battery in the temperat-
ure range between -20 °C and 50 °C.
– Do not store the battery for an exten-
ded period of time if it is fully charged
or fully discharged.
Installing the base station
▶ Check whether any household wiring
could be damaged in the installation
area.
▶ Do not install the base station horizont-
ally or vertically above, below or next to a
socket.
3
6
→ Fig.
-
Inserting and charging the bat-
tery
7
8
→ Fig.
-
Charging
▶ Only use the battery in connection with
the Bosch appliance.
▶ Only charge the battery using the ori-
ginal charging cable.
▶ Only use batteries from the Power for
ALL 18 V series.
Note: The power supply unit on the char-
1
ging cable
and the appliance heat up
while charging. This is normal and harm-
less.
Charging using the charging cable
→ Fig.
9
-
10
Charging in the base station
▶ Ensure that children do not play with the
appliance, even when it is in the base
1
station
.
→ Fig.
11
-
12
1
Depending on the appliance specifications
22
Charging using the quick charger
Press the release button and remove the
1.
battery to the rear.
13
→ Fig.
Observe the enclosed instructions.
2.
Installing the appliance
14
15
→ Fig.
-
Switching on the appliance
▶
Press
.
→ Fig.
16
Setting the power
→ Fig.
17
-
18
Vacuuming with accessories
→ Fig.
19
-
20
Storing accessories
→ Fig.
21
-
22
Using the flexible extension
hose
→ Fig.
23
-
24
Cleaning the appliance
Requirement: The appliance is switched
off.
1.
Disconnect the appliance from the char-
1
ging cable
.
Clean the appliance and the accessory
2.
with a soft cloth and a commercially
available plastic cleaner.
Emptying the dust container
→ Fig.
25
-
28
Cleaning the filter unit
▶ Never allow the filters to come into con-
tact with liquids.
→ Fig.
29
-
35
Cleaning the power brush
→ Fig.
36
-
38
1