Andis TS-1 Instrucciones De Uso Y Cuidado página 6

UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter.
Interchangeable input plugs are included for use in most countries around the
world (Figures A-F). Plugs included may vary by kit.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on
plug until it releases from power adapter.
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on
input plug (Figure G).
2. Gently push input plug into power adapter until it snaps into place.
OPERATING INSTRUCTIONS
• The battery is not intended to be replaced by the
user.
• The battery must be removed from the appliance
before it is scrapped.
• The appliance must be disconnected from the
supply mains when removing the battery.
• The battery is to be disposed of safely.
CHARGING SHAVER
The shaver has not been charged at the factory. Please charge the shaver
for a minimum of 2 hours before the first use for maximum performance.
This battery charger is intended for use with Andis model TS-1 lithium-ion
battery with a rated capacity of 3.7V
adapter from the carton. Plug the adapter into a 100-240V AC outlet, or
according to your local power standards. Note that the shaver ON/OFF switch
must be in the OFF position for the battery to charge.
Plug the cord adapter directly into the inlet on bottom of the shaver (Figure H).
The green charging indicator light on the shaver will turn on. After battery is
fully charged, the green charging indicator light will turn off.
6
2.96 Wh. Remove the shaver and AC