Andis TS-1 Instrucciones De Uso Y Cuidado página 9

USER MAINTENANCE
Cleaning and user maintenance shall not be made
by children without supervision.
If shaver is to remain unused for a long period of time, store in a safe, cool,
dry place. Do not wrap cord tightly around shaver. Do not hang the shaver by
the power cord. Other than the recommended maintenance described in
this manual, no other maintenance should be performed, except by
Andis Company or an Andis authorized service station.
IMPORTANT: For best shaver performance and results, it is recommended that
you replace your shaver's foil assembly and cutters every six months.
TO REPLACE FOIL ASSEMBLY
1. Remove the foil assembly by pressing the round assembly lock button
located on the right side of the shaver. Grasp the foil assembly on both sides
and gently lift it off the shaver (Figure I).
2. Position the replacement foil assembly over the cutters. Be careful not to
damage the foils. Gently slide the foil assembly down until it snaps firmly
into place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure J).
2. To replace a cutter, hold it on both sides and line up the small metal shaft on
its underside with the notch on the shaver drive and push down firmly until
it snaps into place.
3. Replace foil assembly.
CLEANING
Regular cleaning is necessary in order to maintain the optimal performance
and maximum comfort from your shaver. Do NOT run shaver, foil assembly or
cutters under water. Use only the small brush (included) to clean.
DRY CLEANING WITH BRUSH
1. Remove the foil assembly by pressing the round button located on the right
side of the unit. Grasp the foil assembly on both sides and gently lift it off of
shaver (Figure I).
2. Gently tap the base of the foil assembly on a flat surface so that the hairs
inside fall out. Do not remove the foils or they may be damaged accidentally.
9