Descargar Imprimir esta página

Andis TS-1 Instrucciones De Uso Y Cuidado página 8

Ocultar thumbs Ver también para TS-1:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance
you know is working).
2. Check to make sure adapter cord is plugged firmly into the shaver.
If failure to charge still exists, return shaver to Andis or an Andis authorized
service station for examination and repair or replacement.
USE WITH CORD ADAPTER
If the shaver powers OFF while in use, the power cord can be directly attached
to continue use in corded operation (Figure H). When the shaver is running
with the power cord attached, the green charging indicator light will remain
on, even if the battery is partially or fully discharged. The shaver will not
charge while in use with the cord attached.
This power unit is intended to be correctly orientated in a vertical or floor
mount position.
FOR SHAVING
1. Keep the unit clean and dry at all times.
2. Remove the protective plastic headguard.
3. Check to make sure the outer foils and inner cutters are not damaged.
Replace damaged parts before using. For more information on replacement
parts, contact Andis or the nearest Andis authorized service station.
4. Ensure that the battery is charged.
5. Wash and dry your skin thoroughly prior to shaving.
6. Slide the ON/OFF switch up to the ON position.
7. Gently stretch the skin of your face with your free hand while moving the
shaver slowly and smoothly against the grain of your beard. Using short,
circular strokes will make the hairs stand out from your face and make
shaving easier. Hold the shaver at a 90 degree angle to your face while
maintaining contact with the foil.
8. In order to achieve the closest shave and avoid unnecessary wear on the
foils, be sure that both foils contact the skin simultaneously at all times.
Holding the shaver at an angle where only one foil contacts the skin will
cause distortion of the foil and may result in skin irritation.
9. To facilitate cutting and avoid foil wear, use minimal pressure to apply the
shaver to your skin.
10. To maximize shaving comfort, be sure to clean the shaver thoroughly after
use.
8

Publicidad

loading

Productos relacionados para Andis TS-1