Lofra Dolcevita Uso Y Mantenimiento página 18

CLEANING
All ordinary maintenance operations must be
carried out:
- after disconnecting the electric power supply;
- always wearing appropriate personal protective
equipment (e.g.: gloves, etc...).
Failure to follow the instructions, or use of unsuitable
products, may pose a risk of fire and/or damage to the
equipment or other objects, for which the Manufacturer
cannot be held responsible.
When cleaning any of the components or accesso-
ries, NEVER use:
- abrasive or powder detergents;
- aggressive or corrosive detergents (e.g. hydrochloric/
muriatic or sulphuric acid).
- abrasive or sharp tools (e.g. abrasive sponges, scrapers,
steel brushes, etc.);
- water sprays
activated carbon filter (filter-
ing/internal recirculation cook-
Fig. 2.
er hood only) see
anti-grease metal filter
STAINLESS STEEL AND OTHER
METAL SURFACES
The INSIDE and the OUTSIDE of the hood should be
cleaned solely by using a damp cloth with little neutral
soap. It is also possible to use a steel specific cleanser,
paying attention to the instructions written on the canister
or bottle.
To conclude the cleaning operation, rinse using a clean
wet sponge or cloth and then use a rag to dry the surface
(in case of satin steel, please rub according to the finish
pattern).
GLASS COMPONENTS
CONTROL PANEL
Please follow the instructions stated above for metal sur-
faces.
18
AND
Fig. 4.