coralwai WAKE Manual De Instrucciones página 27

STEP 3 - INSTALLATION OF THE SMART ELECTRONIC TAP HOSE
Installation of the smart electronic tap hose.
1. Remove the 1/4 PE pipe from the tap quick-fit connector (Figure 3).
2. Insert one end of the 1/4 PE pipe tightly into the 1/4 quick-fit connector (Figure 4).
3. Insert the power cord of the smart electronic tap into the device interface (Figure 5).
1
5
Figure 3
Figure 6
3
4
2
6
Figure 4
Figure 7
1. The light will turn red when the
PCBA filter reaches the end of its
service life.
2. TDS numbers
3. The light will turn red when the
RO filter reaches the end of its
service life
4. TDS output
5. TDS input
6. TDS numbers
27
Figure 5
EN