Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
Before to carry on any operation, please read carefully and take into account the
following safety instructions:
- Only a qualified technician can install, adjust and maintain this device. All this operations must
be always done according to the current legal European Standards of installation and according
the local installation regulations as well.
- Be careful when the casing of the appliance is dismantled because active parts of the device
become accessible and then there is a potential risk of an electric shock.
- Before any electrical manipulation, the electrical current must be cut in order to avoid any
electric shock risk
- Be careful because local installation requirements can ask more than 1 m of safety distance.
Take into account these local requirements as well.
- Means for disconnection, with contact separations at least 3 mm (0.12"), must be incorporated
in the fixing wiring involving all poles, accordingly to the current legal European Standards.
- The installer must make sure that the electric system is grounded in accordance with the law in
force.
- This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
- The device could not be installed on a normally inflammable surface.
- To fix the hand dryer to the wall follow the instructions of this manual and use the template
provided with the device as well. To fix the machine with adhesives or similar methods is
forbidden by the European safety standards.
INTRODUCTION
'Dualflow Plus' range hand dryers offer the following technical features:
Universal voltage. The equipment works correctly for the values of voltages in the following
ranges:100-120V/220-240V50/60Hz.
It incorporates a BLDC type motor 'brushless' without maintenance (without 'brushes').
Automatic operation. Hand detection is based on Infra Red (IR) movement sensors. Two
pairs of those sensors emit a continuous beam of IR light. The introduction of the hands
causes the interruption of the IR light beam and switch on the dryer.
The speed of the air generated by the hand dryer can be adjusted, to achieve an optimum
balance between the drying power and noise level.
-11-
www.mediclinics.com
ENGLISH
Publicidad
