Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.
To remove door from hinges:
1. Using a flathead screwdriver, separate the axis from Hinge 1. Set aside.
2. Open the door about 20°around the axis of Bottom Hinge 2, then
lift the door off Bottom Hinge 2 and set door aside.
To replace door on hinges:
1. Using a flathead screwdriver, remove the plug buttons from the
screw holes opposite the door hinges, top and bottom.
2. Replace the axis on the Hinge 1 and tighten it firmly. Remove
Hinge 1 and install it with left latch block ( in accessory bag ) on the
opposite bottom side.
3. Remove the Hinge 2 and take down the right latch block,
place Hinge 2 on the opposite top side. Separate the axis from
Hinge 2 and set it aside.
4. Keep the handle apart from the hinge side. Align the door on the
bottom hinge 1 and replace axis on the hinge 2. Tighten it firmly.
5. Push the plug buttons into the original screw holes.
Reversing the Door Handle
Using a Phillips screwdriver, remove the two screws pre-installed on the left side of
1.
the door. The door has two screw holes on the rear side allowing you to install the
handle. Align the handle with the screw holes and attach with the two screws.
Tighten screws firmly but do not over tighten.
11
Publicidad
