Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR ICE-MAKER
Ice making stage
1.
Turn on the water tap.
2.
Press the ON/OFF button.
3.
After 3 minutes, the machine will automatically go to the ice-making stage, and the sound of water
flowing will be heard. (The ICE indicator light (GREEN) will blink during this process.)
4.
Press the MODE button to quick start the Ice-Making process and allow the water trough to begin
to fill automatically. (The ICE indicator light (GREEN) will blink during this process.)
5.
When the batch of ice has been fully formed, the ice will automatically be harvested and drop to the
ice storage bin. (The HARVEST indicator light (YELLOW) will blink during this process.)
6.
When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the bin-full
sensor open. The machine will stop making ice automatically. (The BIN-Full indicator light (RED)
will blink to indicate the bin is full or the sensor is being blocked.)
7.
The unit will start making ice again after ice cubes are removed or when the bin-full sensor swings
back to operating position.
approximately 3 minutes, then the system will automatically begin the ice-making process again.)
IMPORTANT:
·
Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.
·
Never turn the water supply tap off when the ice maker is working.
·
Never touch the evaporator when unit is running!
·
To prevent ice from melting and to ensure proper ice formation, keep the door closed except
when removing ice from the bin.
Ice harvest stage
(The BIN-Full indicator light (RED) will continue to blink for
15
Bin full stage
Publicidad
