Publicidad
Idiomas disponibles
Idiomas disponibles
11
11A
11C
11D
11E
11F
11 POP-UP INSTALLATION
Apply a small bead of putty underneath the Flange (11A) and place a ring of
putty around Drain Opening (11B) of sink. Apply PTFE plumber's tape to all
threaded fi ttings according to manufacturer's instructions. Insert Flange (11A)
into Drain Opening (11B). From underneath, insert Rubber Washer (11C) and
Friction Washer (11D) over the bottom of Flange (11A). Thread Locknut (11E)
until Rubber Washer (11C) seats securely inside Drain Opening (11B). Thread
Drain Body (11F) to bottom of Flange (11A). Hand tighten and adjust the Drain
Body so that the Ball Rod Opening (11G) faces the rear. Wrench tighten Locknut
(11E) and remove excess putty.
12
12A
12F
12D
12 BALL ROD INSTALLATION
Drop the Stopper (12A) into the Drain Body (12B) from the top with the Off-Set
(12C) facing rear. From below, insert the Ball Rod (12D) into the Ball Rod Opening
(12E) through the Stopper Hole (12F) and secure with the Nut (12G).
11B
11G
12C
12G
12E
12D
12B
ENGLISH
13
13 POP-UP ROD LINKAGE & ADJUSTMENT
Place one end of Spring Clip (13C) on end of Ball Rod (13B). Insert Ball Rod
(13B) across and through hole in Strap (13D). Secure other end of Spring Clip
(13C). Insert bottom of Lift Rod (13A) into hole at top of Pop-Up Strap (13D).
Tighten with Thumb Screw (13E). Adjust Lift Rod (13A) height by sliding the
Lift Rod (13A) along the strap (13D) or by adjusting the hole in which Ball Rod
(13B) goes through Strap (13D). Be sure to leave enough space between Lift
Rod Knob (13F) and Spout Hub (13G) when Lift Rod is down.
14
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
15
CLOSED
OPEN
15 FAUCET FUNCTIONS
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-
clockwise, open-counterclockwise. The Spout (15A) can be rotated around the
Faucet Body in any direction.
4
13A
13C
FAUCET FUNCTIONS
HOT
COLD
15A
13F
13G
13E
13D
13B
CLOSED
OPEN
Publicidad
