Publicidad
2.
Following all local codes, drill and prepare the
mounting holes.
3.
Securely fasten the mount to the mounting
surface with the appropriate fasteners.
4.
If needed, seal all mounting holes so that no
moisture can leak into the mounting surface.
5.
Screw the camera into the mounting bracket.
Ensure that the camera is firmly attached to the
bracket.
6.
Connect a 75 ohm coaxial video cable to the
video cable, and connect a 12 VDC or 24 VAC
power supply to the power cable.
7.
Adjust the camera position and angle as
required.
8.
If necessary, use a flat blade screwdriver to
adjust the zoom first, and then adjust the focus
(Figure 3 on page 9).
Specifications
Power supply
24 VAC/12 VDC
13 EN
Publicidad
