rcf L-PAD 12CX Manual Del Usuario página 6

FUNCTIONS
EQ
A three‑band EQ is available
for mono channels:
HI = ±15 dB@12 kHz
MID = ±15 dB@2.5 kHz
LOW = ±15 dB@80 Hz
Dual‑band EQ for stereo channels:
HI = ±15 dB@12 kHz
LOW = ±15 dB@80 Hz
AUX: It is an auxiliary send, level ‑∞ to +15 dB. The signal is routed to the AUX SEND output jack. The POST/PRE function determines whether to extract
the signal after the fader position or independently from it.
PRE/POST button: When released, the signal is extracted in pre‑fader position (independently from the fader level); when pressed, the signal is extracted
from post‑fader position (the send level depends on the fader level).
FX SEND: This potentiometer sends the signal to the internal effects device. The signal is also routed to the FX output jack. The signal is extracted in post‑
fader position.
PAN or PAN/BAL: This control defines the signal stereo imaging for mono channels or left‑right balance for stereo channels.
MUTE button: Press this button (red LED on) to mute the channel.
PFL button: Press this button to listen the signal through the PHONES output even if the fader is in ‑∞ position or muted. This function is useful to check
the channel input level (see the OUTPUT LEVEL meter).
GROUP 1-2 button: Press this button to route the channel signal to the group 1‑2 audio output. In this case, the PAN/BAL position control defines the
quantity of signal routed to GROUP 1 or GROUP 2.
L-R button: Press this button to route the channel signal to the MAIN MIX output.
FADERS Ch. 1 - Ch. 4:
MONO Channels level control
FADERS Ch. 5/6 - Ch. 7/8:
MONO/STEREO channels level control
FADERS Ch. 9/10 - Ch. 11/12:
STEREO channels level control
6