rcf L-PAD 12CX Manual Del Usuario página 7

FUNCTIONS
MAIN MIX output: XLR balanced male connectors. Plug in your active speakers or
main sound reinforcement system amplifier (for passive speakers) of here. The output
level is +4 dBu. This output is repeated on the TRS jack.
CONTROL ROOM output: Plug your studio monitor or local speakers into these TRS
jacks.
GROUP OUT output: TRS jacks. Plug in the lines to be routed to locations or devices
other than MAIN here.
AUX SEND output: Plug a wedge stage monitor or external FX device into this TRS
jack. The processed signal from the FX device is returned to the mixer via the Stereo
Return jacks.
FX SEND output: The signal going to the Internal FX is replicated in this TRS Jack for
different application. If the internal FX device is not used, FX SEND can be used as
second AUX SEND for connecting a further wedge monitor.
PHONES: TRS stereo jack, Tip = Left, Ring = Right, Sleeve = Common Earth. Plug in
your headphones here to listen to MAIN MIX or PFL when pressed.
FOOTSWITCH: TS connector, Tip = FX, Sleeve = EARTH. Connect a footswitch here.
Press once to bypass the FX, press again to resume the FX. The same function is
available for the FX MUTE button.
OUTPUT LEVEL: These LEDs show the MAIN MIX OUTPUT level.
Keep under CLIP level to prevent generating distorted sounds or dangerous sound
levels.
ST RETURN control: This defines the STEREO RETURN input signal level routed to
MAIN MIX output.
TO AUX control: This defines the signal STEREO RETURN input level routed to AUX1
output.
SEND AUX control: This is the AUX SEND master level control.
FX control: This is the FX SEND master level control.
CONTROL ROOM/PHONES control: This defines the signal level routed to CONTROL
ROOM output and PHONES output.
MAIN MIX-GROUP 1-2 switch: In upper position allows you to listen the MAIN MIX
through the CONTROL ROOM speakers. When pressed, it allows to listen to GROUP
1‑2 via the CONTROL ROOM speakers.
2TK IN/MP3 control: This defines the signal level from the 2TK IN input or from
optional cards (such as the RCF mixing consoles player, recorder or Bluetooth cards)
routed to MAIN MIX output.
TO MAIN MIX/TO CONTROL ROOM switch: Defines where to route the signal coming
from 2TK IN or optional cards: to MAIN MIX when in upper position, to CONTROL
ROOM when pressed (lower position).
INTERNAL FX PROGRAM selector: This encoder can be used to select one of the 100
effects available on the internal DSP. Press the encoder to confirm the selection. See
the FX LIST to select the required effect.
FX TO AUX control: This defines the signal level of the internal FX return routed to the
AUX.
FADER GROUP 1-2: GROUP 1‑2 signal level control. The GROUP 1‑2 signal is routed
to the MAIN MIX when the L‑R button is pressed.
FADER MAIN MIX: MAIN MIX output level control.
7