rcf L-PAD 12CX Manual Del Usuario página 8

FUNCTIONS
HOW TO GET SOUND FROM A RCF MIXING CONSOLE
1. Turn your RCF Mixing Console on.
2. Set all the faders and controls to minimum position (0 or ‑∞)
3. Plug a microphone into the XLR connector ‑ MIC input of channel
1.
4. Connect your speaker system to the MAIN MIX output and turn it
on.
5. Press the PFL button. Sing into the microphone and adjust the
GAIN control until the OUTPUT LEVEL is shown by means of LEDs
(all green LEDs should light up and the first yellow LED should do
so occasionally).
6. Press again the PFL button to cancel the operation.
7. Adjust the FADER up to "0" position.
8. Check whether the MUTE button is in released (UN‑MUTED
channel).
9. Press the L‑R button to route the channel signal to MAIN MIX.
10. Carefully turn up the MAIN MIX fader to reach a reasonable
sound level.
11. Enjoy the quality of your RCF mixing console.
HOW TO IMPROVE THE SOUND
The RCF mixing console implements several powerful tools to improve the sound quality of your music even more.
COMP: Turn the COMP control clockwise to add a compression effect to the signal. This allows to control the dynamic of the signal, limiting peaks and
gaining level in case of low signals.
EQ: A three‑band EQ is available on each mono channel, while a dual‑band
EQ is available on stereo channels 9‑10 and 11‑12. Adjust these parameters
to subtract noise frequencies or magnify desired sounds.
8