GE HDM1853 Manual Del Propietário página 35

Replacing the light bulbs.
Remove screw
Cooktop Light/Night Light
On models JVM1850, JVM1851, EMO4000 and
HDM1853, replace the burned-out bulb with a 120 volt,
40-watt incandescent bulb (WB36X10003), available
from your GE supplier.
On models JVM1870, JVM1871, JVM3670 and
JVM2050, replace the burned-out bulb with a 120 volt,
20-watt halogen bulb (WB36X10213), available from
your GE supplier.
To replace the bulb(s), first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
Remove the screw at the left edge of the light
2
cover and push on the right edge of the cover
to open.
Be sure the bulb(s) to be replaced are cool
3
before removing. After breaking the adhesive
seal, remove the bulb by either gently turning
(for models JVM1850, JVM1851 and EMO4000)
or pulling straight out (for models JVM1870,
JVM1871, JVM2050 and JVM3670). Replace
with the same size and type bulb.
Raise the light shield and replace the screw.
4
Connect electrical power to the oven.
ge.com
35