Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
E
Cooktop Burners
Checking the igniters
E2
Operation of the electric igniters should
be checked after the cooktop and supply
line have been carefully checked for leaks
and the cooktop has been connected to
the electrical power.
a. Push and turn a burner valve to the LITE
position.
• The burner valve should light when gas
is available to the burner
• Once the burner lights, it should be
turned out of the LITE position.
b. Try each valve separately until all burners
have been checked.
E3
Burner ignition
Cooktop Spark Ignition—When you turn
the cooktop knob to LITE, the spark igniter
makes a series of electric sparks (ticking
sounds) which light the burner. During a
power failure, the burners will not light
automatically. In an emergency, a cooktop
burner may be lit with a match by following
the steps below.
WARNING:
burners with a match is dangerous. You
should match light the cooktop burners
only in an emergency.
a. Light a match and hold the flame near the
burner you want to light. Wooden matches
work best.
b. Push in and turn the control knob slowly.
Be sure you are turning the correct knob
for the burner you are lighting.
NOTE: If the burner does not light within five
seconds, turn the knob off and wait one minute
before trying again.
Lighting gas
(cont.)
The burner flames
E4
Turn each burner on. Flames should be blue
in color with no trace of yellow. The burner
flames should not flutter or blow away from
the burner. The inner cone of the flame
should be between 1/2" and 3/4" long.
Burners should be checked frequently
WARNING:
measure the inner cone of the flame,
please use caution. Burns could result.
25
If you attempt to
Publicidad
