Publicidad
Idiomas disponibles
Idiomas disponibles
6
Solution suggestions for problems
Problem
Drying process
takes too much
might have not been cleaned.
time.
* Cover filter and filter drawer
Laundry come
might have not been cleaned.
out wet at the
* Excessive laundry might have
end of drying.
been loaded in.
* It might have not been plugged
in.
* The loading door may be ajar.
Machine does
* Programme might have not
not switch on or
been set or the «Start/Pause/
the programme
Cancel» button might have not
does not start.
been pressed.
Machine is not
* «Childproof lock» might have
activated when
been activated.
set.
* The condenser cover on the
models with a condenser might
not be closed securely.
Programme has
been interrupted
* The loading door may be ajar.
without any
* Electricity may be cut off.
cause.
Laundry has
* A programme suitable for the
shrunk, become
laundry type might have not been
felted or
used.
deteriorated.
Drum lightning
does not come
* The machine might have not
on.
been started by using the On/Off
(for models
button.
equipped with a
* Bulb may have blown.
lamp)
* The 2-hour anti creasing
"Final / Anti-
programme to prevent laundry
creasing" LED
from creasing might have been
flashes.
activated.
"Final / Anti-
creasing" LED
* Program has come to an end.
is on.
* A heat sensor failure has
The "Drying"
occurred. Machine ends the
LED flashes.
programme without heating.
"Filter cleaning"
* Filter might have not been
LED flashes.
cleaned.
Also for products equipped with a condenser
"Water tank"
* Water may be full.
warning LED is
* Anti-creasing programme might
on.
be running.
"Condenser
* Filter drawer/Condenser might
cleaning" LED
have not been cleaned.
is on.
A
Call an authorized service agent if the problem persists.
Cause
Cover filter and filter drawer
Explanation / Suggestion
* Meshes of the filter may be clogged.
Wash with water.
* Meshes of the filter may be clogged.
Wash with water.
* Do not overload the machine.
* Make sure that the machine is
plugged in.
* Make sure that the loading door is
properly closed.
* Make sure that the programme
has been set and it is not in "Pause"
mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover
and the red lock is closed securely.
* Make sure that the loading door is
properly closed.
* Press «Start/Pause/Cancel» button
to start the programme.
* Dry only the laundry which is suitable
for drying in your machine after
checking the labels on your clothes.
* Select a programme with suitable
low temperature for the laundry type to
dry your clothes.
* Make sure that the machine is On.
* Call the authorized service to replace
the bulb.
* Turn off the machine and take out
the laundry.
* Turn off the machine and take out
the laundry.
* Turn off the machine and take out the
laundry. Call your authorized service.
* Clean the cover filter.
* Drain the water in the water tank.
* Clean the filters in the condenser/
filter drawer under the kick plate.
15 EN
Publicidad
