Publicidad
Idiomas disponibles
Idiomas disponibles
InstallInG tHe Interface
from the 24-way harness:
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Yellow wire to the constant wire of the aftermarket radio.
• Connect the Blue wire to the antenna turn-on of the aftermarket radio.
• Connect the Blue/White wire to the amp turn-on of the aftermarket radio
(if populated on factory side).
These wires are to be connected if the vehicle does not have the SONY/THX system
• Connect the Violet wire to the right rear positive wire of the aftermarket radio.
• Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the left rear positive wire of the aftermarket radio.
• Connect the Green/Black wire to the left rear negative wire of the
aftermarket radio.
from the 16-Way Harness:
Connect the RSE/SYNC/SAT RCA's to the AUX in on the aftermarket radio (if retaining
SYNC) Connect the From 3.5 RCA's to the AUX in on the aftermarket radio (if SYNC
is not present).
from the 8-Way Harness:
Connect the White RCA to the sub out of the aftermarket radio.
AX-ADFD01
(continued)
Installing the aX-adfd01
1. With all the connections completed, plug the 22- and 16-pin harnesses into the
AX-ADFD01.
2. Plug the 24, 16, and 8-pin Ford harness into the vehicle side harness, and plug
the aftermarket radio harness into the aftermarket radio.
3. Reconnect the negative battery terminal.
4. Initialize the interface by cycling the key by turning.
audio level adjustment
1. Start your vehicle and turn on the radio having audio playing.
2. Turn your aftermarket radio's volume up 3/4 of the way.
3. With a small screwdriver adjust the potentiometer clockwise to raise the
audio level and counterclockwise to lower the audio level.
4. Once at desired level your audio adjustment is complete.
the XIa-lcd screen (optional)
The XIA-LCD will allow you to view factory installed SYNC or satellite info
(if tuner is separate).
1. Channel up: Allows channel up function
in satellite mode.
2. Channel down: Allows channel down
function in satellite mode.
5
1
3
2
4
3. Select/Enter button: Selects current
item on screen.
4. Escape/Exit button: Exits to previous screen.
5. Screen: This is where your satellite/SYNC
information is viewed.
Publicidad
