Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1
• Use the handles (1) on the sides of the wine cellar to
transport the appliance
• Lay the power cable behind the wine cellar, inside the
cabinet
Leveling your wine cellar: Wine cellar must be leveled
BEFORE loading your wines.
INSTALLATION INSTRUCTIONS
1. "Built in" wine cellars are front venting but are not
designed to be fully integrated behind a joinery door.
2. Please follow the installation diagram when installing
built-in wine cellars. No less than the minimum installation
dimension, or it will affect the venting of cellar.
3. These wine cellars take air from the back of the ventilation
frame and expel it upwards at the back.
4. "Built in" wine cellars have a power switch located on
the control panel so power point location is not critical.
5. The wine cellar requires a standard 240 volt/10 amp
power point. (Or according to different countries
specifications).
6. The power cord is 2.0m in length and is fixed on the
right side at the back when looking from front of cabinet.
7. As with most appliances of today, the wine cellar has
sensitive electronic components which are susceptible to
damage through lightning and electricity supply faults.
It is therefore advised to use a power surge protector to
avoid problems of this nature.
In Hot climate zone, an air vent or grid, with a minimum
ventilation size of 200mm x 40mm MUST be cut out at the
rear top of the back partitioning or at the top of either side
of the partitioning, allowing cool fresh air full access to flow
into the 50mm gap located at the rear of the cabinet.
This air vent or grid must not be opened on the same side
as other appliances such as ovens or an area that is sealed
and without access to fresh cool air. Failing to comply with
the above specifications could result in WARRANTY void.
4
Note: The appliance must be positioned so that
the plug is accessible after installed.
ACCESSORIES SUPPLIED
ACCESSORIES ON REQUEST
Cacciavite
x 2
Avvitatore
Publicidad
