Publicidad
Idiomas disponibles
Idiomas disponibles
TO LIGHT
TIPS:
Before Beginning ●Read and understand the instructions thoroughly.
●Check and make sure that all parts are present.
●For future reference, save this instruction sheet.
1
Locate the burner control knob and make sure it is in the "OFF" position.
2
Connect propane (LP) cylinder. (See above pages).
3
Open LP tank valve slowly.
4
Push in igniter button to create sparks at the electrode and hold.
5
Push and turn burner control knob to the "LOW" position. Continue to push the control knob for 15-30 seconds after ignition.
6
If ignition does occur within 30 seconds, turn the burner control knob to "OFF", wait 5 minutes for gas to clear and repeat the
lighting procedure. If burner still will not light, refer to the Troubleshooting Section.
7
Once the appliance is lit, flame height can be changed by adjusting the burner control knob between the "High" and "Low"
8
Always check burner flames periodically to ensure proper operation. Flames should be mostly yellow with some blue for best
performance. (See diagram)
If the burner does not ignite with the burner control valve open, gas will continue to flow out of the burner and could
USING A LONG MATCH OR LIGHTER
1
Connect propane (LP) cylinder (see above pages).
2
Before lighting, move the lava rocks with a small shovel to allow access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are completely cooled.
3
Locate the burner control knob and make sure it is in the "OFF" position.
4
Wearing heat resistant gloves, position a long lit match or lit long neck lighter close to the burner
ports. DO NOT lean over the burner while lighting.
5
Push and turn burner control knob to the "LOW" position. The burner should lit within 5 seconds.
6
If ignition does occur within 5 seconds, turn the burner control knob to "OFF", wait 5 minutes for
gas to clear and repeat the lighting procedure. If burner still will not light, refer to the
Troubleshooting Section.
7
Flame height can be changed by adjusting the burner control knob between the "LOW" and
"HIGH" positions.
8
Always check burner flames periodically to ensure proper operation. Flames should be mostly
yellow with some blue for best performance.
CAUTION
accidentally ignite causing injury or property damage.
10
Publicidad
