Publicidad
Idiomas disponibles
Idiomas disponibles
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Charging a Hot or Cold Battery Pack
The green indicator light on the charger base indicates that the
battery pack temperature is outside the charging range. Once
the pack is within the acceptable range, normal charging will
take place and the red light will be continuous. Hot or cold
battery packs may take longer to charge.
Lithium-Ion Charging Status
Charger
Battery
Base
Pack
Indicator
Temperature
Light
Too hot
Green
Normal range
Red
Too cold
Green
Assembly
m
WARNING!
Do not insert the battery and the safety key
until assembly is complete. Failure to comply could result in
accidental starting and serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the battery and the safety key are removed from the unit.
Failure to heed this warning could result in serious personal
injury.
m
WARNING!
The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the reel mower, follow these instructions
to assemble the appliance.
Handle Assembly
1. Insert the ends of the lower handle frame into the sockets
on both sides of the mower base. Lock with the lower
handle knobs provided (Fig. 5).
Battery
Pack
Charging
Indicator
Status
Light
Flashing
Not charging
together
Flashing
Normal
one by one
charging
Flashing
Not charging
together
Fig. 5
Lower handle
frame
Socket
Lower
handle
knob
2. Fit the middle handle bars on both sides of the lower
handle frame, aligning the holes. Secure with two sets of
handle knobs and bolts (Fig. 6).
NOTE: Each middle handle bar has 2 holes on the top and
the bottom. Adjust the handle assembly to the optimal
position by aligning with the hole at the desired height.
Fig. 6
3. Fit the upper handle frame on both middle handle bars, as
shown, aligning the holes. Secure with the remaining two
sets of handle knob and bolt (Fig. 7).
Fig. 7
Middle handle
bars
Lower handle
frame
10
Socket
Lower handle
knob
Middle
handle bars
Handle knob
+ bolt
Lower handle
frame
Upper handle
frame
Handle knob
+ bolt
Publicidad
