Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!! Have you read the "General Safety Rules" and "Specific Safety Rules
and Symbols" of this manual? If not, please do so now before you operate this rotary
tool. Your safety depends on it!
Every time you use the rotary tool, you should verify the following:
1.
All accessories being used are in good condition and not damaged in any way.
2.
Workpiece is properly secured and the accessory is tight.
3.
Safety glasses are being worn.
4.
After powering on the tool, keep it running about 1 minute in no-load operation.
Failure to adhere to these safety rules can greatly increase the chance of injury.
SELECTING PROPER SPEEDS
There are 9 speed settings in this tool showed as below:
SPEED SETTINGS
Different speed settings are required depending upon the type of operation being
performed. The following chart outlines those basic speeds (For reference only –
Speed selection may vary due to the actual operation & application.):
OPERATION TYPE
Sanding
Cutting metal
Sanding wood
Cutting hard metal
Engraving metal
Sawing
De-burring
Drilling holes
Removing rust
Sharpening
Polishing
1English1
OPERATION
REFERENCE SPEED (/min)
1
2
3
4
5
6
7
8
9
RECOMMENDED SPEED SETTING
English
5000
|
|
|
|
35000
9
9
9
7, 8
7
6,7
5
4, 5
4
2, 3
1
-10
Publicidad
