Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING OR REMOVING BATTERY PACK
TO REMOVE BATTERY PACK: Depress the battery pack release button (9) and pull
the battery pack (10) out of tool.
TO INSTALL BATTERY PACK: Push the battery pack (10) onto tool until it locks in
place.
CHANGING THE COLLET
Some accessories require the use of different sized collets. Collet sizes are 3.18 mm,
2.38 mm, 1.59 mm or 0.79 mm. It is important to ensure that the collet size matches
the accessory.
C
Lock
Loose
Using a collet that is too large for the accessory will result in the accessory possibly
being thrown from the tool causing serious injury.
1.
Turn off the tool.
2.
Depress the spindle lock button (see above A.)and slowly turn the collet nut (see
above B.) until the spindle lock button locks the spindle.
3.
While holding the spindle lock button down, turn the collet nut counter-clockwise
by wrench (see above C.) until it is removed.
4.
Remove the collet (see above D.) by pulling it out of the spindle (see above E.) .
5.
Insert the replacement collet into the spindle and replace the collet nut by turning it
clockwise using the wrench whilst holding the spindle lock button down.
NOTE
To prevent damage to collet, do not tighten the collet nut without an accessory
installed in the collet.
1English1
ASSEMBLY
A
B
English
E
D
1/32"
1/16"
3/32"
1/8"
-8
Publicidad
