Publicidad
Idiomas disponibles
Idiomas disponibles
2610067310_04-21_GWS18V-8.qxp_GWS 4/1/21 10:06 AM Page 13
Lock Nut and Backing Flange
Your tool is equipped with a threaded
spindle for mounting ac ces sories. Always
use the supplied original BOSCH lock nut,
and backing flange, that has the same
thread size as the spindle. Backing flange is
keyed to output shaft (Fig. 4). Always make
sure that the lock nut is tightened correctly
with the supplied wrench.
Disc Grinding Wheel Assembly
1. Disconnect battery pack from tool.
2. Be sure that wheel guard is in place for
grinding.
3. Place BACKING FLANGE and GRINDING
WHEEL on the spindle.
4. Thread on the lock nut and tighten nut
using the lock nut wrench, while holding
TO REMOVE: Reverse procedure.
the spindle lock. (Fig. 4).
WHEN USING SPIN-ON WHEELS
1. Disconnect battery pack from tool.
2. Be sure that wheel guard is in place for
grinding.
3. Thread wheel directly onto spindle
without using the supplied flanges.
TO REMOVE: Reverse procedure.
All parts of a spin-on wheel must be within
lip of grinding guard (Fig. 5). If spin-on
wheel is past lip of guard, do not use that
wheel as it does not fit on this grinder.
The tool will vibrate excessively and may
cause loss of control and the accessory may
burst.
Assembly
Do not use accessories
that run eccentrically.
Fig. 4
Spindle
Lock Nut
Type 27
Grinding
Wheel
Lock Nut
FIG. 5
Lip of
Guard
-13-
Type 27
Wheel
Guard
Backing
Flange
Type 27
Grinding
Wheel
Spindle
Backing
Flange
Spin-On
Wheel
Publicidad
