Citizen CT-E651 Manual De Usuario página 49

3.11 Selecting a Paper Type
Paper type selection is available by the combination of memory switches MSW4-4
and MSW4-5 by the used of "Memory Switch Select Mode". In addtion, the following
procedure is available.
1. Enter Selecting Paper Type mode.
1) With the top cover open, turn on the printer power switch while pressing and holding the
FEED key.
The buzzer sounds and the status LED flashes in green.
2) After releasing your finger from the FEED button briefly, press the FEED button
consecutively four times.
Next, when the paper is set in place and the top cover closed, the buzzer sounds four short
times and paper selection mode starts.
2. Select Paper Type.
Press the FEED key to match the paper used with the paper type displayed by the status
display LED.
(Refer to the table below.)
Paper roll
Thermal roll paper
Black mark paper
Label media
3. Save the selected Paper Type to the Printer.
Open the top cover and then close it as it is.
The paper type selected is stored in the printer memory switch as shown in the table below.
The paper type setting mode finishes and the printer restarts automatically.
Paper type
Thermal roll paper
Black mark paper
Label media
POWER LED PAPER LED
Flashing
Press the FEED key ↓
Flashing
Press the FEED key ↓
Flashing
Return to receipt paper selection
Black mark paper/label media
Black mark paper/label media
—
CUTTER LED
Unlit
Lit
Lit
MSW
4-4
Thermal roll paper
49
—
Buzzer
Unlit Once
Unlit Twice
Lit Three times
4-5
-
Black mark detection
Label gap detection