Publicidad
SURFACE INSTALLATION AND ELECTRICAL WIRING
7. Drive the #10 Screws [SS676] provided with the Surface Mount Kit (sold separately) into the holes in the side kit brackets. Use a
penny (as detailed in figure 4 below) to set the depth distance.
8. Orienting the sidekit as shown below, insert the Screw Heads into the keyholes on the side of the upper and lower Light Brackets,
then slide the sidekit down into place.
Note: If the bracket is not oriented correctly, the side kit cannot be lowered into place and may fall, resulting in damage.
Note: If the Sidekit feels loose, move the sidekit back and forth to determine which screw feels loose. Lift and remove the sidekit from
the brackets and rotate the loose screw a 1/4 turn clockwise, repeating as necessary.
Note: If the Sidekit does not lower into place, remove the sidekit from the keyholes and rotate the screws a 1/4 turn counterclockwise.
7
8
Front
Rear
toward
toward
user
wall
1/16" (1.52 mm)
or the thickness
of a penny.
SS676
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
Part no. 209-1400 17-NOV-2022
12
www.robern.com
800.877.2376
Tenor Light
Publicidad
