Publicidad
MOUNTING THE BRACKETS BETWEEN CABINETS FOR GANGING
Note: A Ganging Kit (refer to the cabinet's instructions, sold separately) is required for the following instructions. All additional
components shown in the following steps will be included with the Ganging Kit. One kit includes enough components to gang two lights
between cabinets.
1. Using two #8 x 3/8" screws [SS344] and two lockwashers [203-1068], attach the mounting brackets to the Electrical Enclosure.
2. Using two #10 x 1/2" screws [SS676], attach each mounting bracket to a ganging block, included in the Ganging Kit.
3. Attach the mounting bracket assemblies to each cabinet with four #10 x 1/2" screws [SS676].
1
3
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
www.robern.com
800.877.2376
2
[SS344]
(2) Screw, #8 x 3/8"
[203-1068]
(2) #8 Lockwasher
[SS676]
(4) Screw, #10 x 1/2"
8
Part no. 209-1400 17-NOV-2022
Tenor Light
Publicidad
