Hilti SI-AT-22 Manual De Instrucciones página 10

Status
2 short tones
4 short tones
3.7 USB interface
The USB interface (type C, USB 2.0) can be used to connect
the torque module to a PC. When this connection is made, the
AT Documentation Software offers a range of functions, including:
• Adding new data records for new fasteners
• Changing / updating existing data records
• Deactivating / activating the documentation function
• Loading the log from the documentation function
• Setting the clock in the torque module
Further information can be found in the documentation for the
AT Documentation Software.
The software can be downloaded from here:
http://www.hilti.com/adaptive_torque_documentation_software
3.8 Items supplied
Adaptive torque module, operating instructions, quick-start guide, USB
cable
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
4 Technical data
Weight in accordance with EPTA proce-
dure 01
Laser class
6 English
Meaning
Warning tone 1
• OK or not OK, as applicable,
depending on the fastener and
the application (e.g.
torquing of a fastener, tightening
torque not detected. See the
section headed Tightening the
threaded fastener in "Adaptive"
operating mode)
• The LEDs flash yellow.
Warning tone 2
• Not OK
• Operation canceled
• The LEDs flash red.
0.24 kg
1
2343814
*2343814*
repeat